How Masonry Buildings Resist Earthquakes Woodside NY

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings in Woodside are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

Local Companies

EuroBuild Construction, Inc.
(212) 361-9147
1133 Broadway
New York, NY
X Builders Inc
347-952-1776
9928 62nd drive
Rego Park, NY
HomeExcellence USA
1-888-896-7950
605 Water street
New York, NY
AJ NYC CONSTRUCTION CORP
(917) 470-0009
2080 EAST 61st ST
Brooklyn, NY
Affordable Homes General Construction LLC
(718) 713-2446
511 Chauncey Street
Brooklyn, NY
Jewish Community Center in Manhattan
(646) 505-4493
334 Amsterdam Avenue @ 76th St
New York, NY
DB CONSTRUCTION
(347) 365-8284
592 BUSHWICK AVE
Brooklyn, NY
911 Restoration
201-646-0055
320 Washington Ave
Hackensack, NY
ADG Construction LLc.
(201) 446-9491
307 Dorothy Street
Fair Lawn, NJ
KS Construction and Kitchen Cabinets
(917) 864-2670
19541 Jamaica Avenue
Hollis, NY
Data Provided by:
  

Provided By:

Source: Masonry Construction
Publication date: January 1, 1990

By Richard E. Klingner

How vulnerable are masonry buildings to earthquakes? How can they be designed to resist earthquakes?

HOW MASONRY BUILDINGS RESPOND

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

For a typical masonry building, these shear loads can be calculated in the following way: Base shear load= (building mass) x (earthquake ground acceleration) x (dynamic amplification factor).

MASONRY SEISMIC DESIGN

Though even moderate ground accelerations can subject masonry buildings to large shear loads, masonry buildings can still be designed to resist these loads. In general, the designer must estimate the lateral inertial forces acting on each element and provide for the transfer of these forces down to the foundation.

INELASTIC RESPONSE OF MASONRY BUILDINGS

A masonry building's earthquake resistance has been described here as a function of wall layout, wall area, and wall strength. These characteristics are often sufficient. Enough wall area can often be provided so that even during a strong earthquake the building's walls remain basically elastic, without any yielding of reinforcement. However, architectural constraints may limit the wall area that can be provided.

Click here to read full article from Masonry Construction

Related Articles
- Grout Pumps Woodside NY
The GHP 2000 pump handles grout or shotcrete, and is effective in grouting small ICF projects. The product is powered by a 20-hp gasoline engine and delivers 7 cu yd of grout/hr. It has a peristaltic pump, comes with built-in jack stands to stabilize the machine, and weighs 1000 lb.
- Galvanized Wall Ties Woodside NY
- High Cement Content Problems Woodside NY
- Galvanized Wall Ties Woodside NY
- Hand-Held Power Saws Woodside NY
- Flashing Factors Woodside NY
- Graphisoft EcoDesigner Woodside NY
- Inner Corner at Base of Wall Woodside NY
- Flue Liners for Masonry Chimneys Woodside NY
- Flashing at Sills Woodside NY