How Masonry Buildings Resist Earthquakes Beacon NY

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings in Beacon are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

Local Companies

Coupart Construction Co., Inc.
(845) 562-5924
2 Lattintown Road
Newburgh, NY
Luis General Contracting
(845) 255-4960
202 Plutarch Road
Highland, NY
Seakill Custom Home Builders, Inc.
(845) 255-5988
46 North Chestnut Street
New Paltz, NY
Winter Sun Construction Inc.
(845) 256-1031
43 North Chestnut Street
New Paltz, NY
Fall Fittings, Inc.
(845) 255-5710
380 State Route 208
New Paltz, NY
Manhattan Pressurized Walls Inc.
877 MPW WALL
29 Booth Road
Chester, NY
Kniffen Builders
(845) 255-6363
27 S. Chestut St.
New Paltz, NY
M. J. Posner Construction Co., Inc.
(845) 255-7187
161 State Route 208
New Paltz, NY
Ultimate Homes, Inc.
(845) 255-9378
2356 Rt. 44/55
Gardiner, NY
New Paltz Agway
(845) 255-0050
145 State Route 32 North
New Paltz, NY

Provided By:

Source: Masonry Construction
Publication date: January 1, 1990

By Richard E. Klingner

How vulnerable are masonry buildings to earthquakes? How can they be designed to resist earthquakes?

HOW MASONRY BUILDINGS RESPOND

Because masonry buildings usually have many structural wall elements, they tend to be stiff laterally. Because masonry buildings are stiff laterally, even moderate earthquakes can subject them to large shear loads at their base.

For a typical masonry building, these shear loads can be calculated in the following way: Base shear load= (building mass) x (earthquake ground acceleration) x (dynamic amplification factor).

MASONRY SEISMIC DESIGN

Though even moderate ground accelerations can subject masonry buildings to large shear loads, masonry buildings can still be designed to resist these loads. In general, the designer must estimate the lateral inertial forces acting on each element and provide for the transfer of these forces down to the foundation.

INELASTIC RESPONSE OF MASONRY BUILDINGS

A masonry building's earthquake resistance has been described here as a function of wall layout, wall area, and wall strength. These characteristics are often sufficient. Enough wall area can often be provided so that even during a strong earthquake the building's walls remain basically elastic, without any yielding of reinforcement. However, architectural constraints may limit the wall area that can be provided.

Click here to read full article from Masonry Construction

Related Articles
- High Cement Content Problems Beacon NY
Portland cement gives a mortar added durability, high early strength, a consistent hardening rate, and high compressive and bond strengths. However, mortar with excessively high cement contents can affect water permeability and durability of the masonry.
- Galvanized Wall Ties Beacon NY
- Hand-Held Power Saws Beacon NY
- Flashing at Sills Beacon NY
- Inner Corner at Base of Wall Beacon NY
- Flashing Factors Beacon NY
- Graphisoft EcoDesigner Beacon NY
- Galvanized Wall Ties Beacon NY
- Grout Pumps Beacon NY
- Flue Liners for Masonry Chimneys Beacon NY