Home Siding Tips Stony Brook NY

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.

Local Companies

Legacy Builders and Remodelers
1363-8 Lincoln Ave
Holbrook, NY
Suburban Landscape Inc
(631)262-0202
75 Larkfield Road
East Northport, NY
Huntington Irrigation
(631)262-1930
Po Box 697
Greenlawn, NY
Coastal Designs
(631)692-4488
63 Round Swamp Rd
Huntington, NY
Looney Lawns
(631)689-0028
3 Glen Hill Drive
Saint James, NY
Kuhn Construction, Inc
417 Main St
Islip, NY
Sipala Landscape Services Inc
(631)586-8842
8 Macniece Place
Dix Hills, NY
Green Is the Color Lawn Care Inc
(631)941-4276
11 Hulse Road
East Setauket, NY
Alex Posillico Landscaping Inc
(631)424-3822
33 Fleets Cove Road
Huntington, NY
Steen Clayton W
(631)261-5442
26 Argyle Dr
Northport, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor