Home Siding Tips Richmond Hill NY

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.

Local Companies

SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Garden Works
(718)222-4820
265 Butler Street
Brooklyn, NY
Larchmont Nurseries and Greenhouses
(914)834-5802
2315 Boston Post Road
Larchmont, NY
Maura BROS & CO Inc
(516)767-2134
137 Haven Avenue
Port Washington, NY
Miller BROS Landscape Maintenance
(516)334-4315
69 Woodcock Road
Westbury, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
Crest Servistar Hardware
(718)388-9521
558 Metropolitan Avenue
Brooklyn, NY
Park Florist
(718)768-9207
158 7th Avenue
Brooklyn, NY
Jimenez Landscaping & Home Improvement
(516)747-7470
16 Plymouth Av
Mineola, NY
JSW Professional Lawn Care Inc
(516)579-7492
2208 Elderberry Drive
Westbury, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor

Related Articles