Home Siding Tips Bayside NY

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.

Local Companies

SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Milburn Electric CO Inc
(516)623-5015
1003 Cornwell Avenue
Baldwin, NY
Supreme Stone & Beyond Inc
(718)596-6602
126 Nostrand Av
Brooklyn, NY
ABC Day Care Center
(718)826-1894
1019 Church Avenue
Brooklyn, NY
Bonavitacola Landscaping
(516)767-1528
100 Haven Avenue Apt 1
Port Washington, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
Paragon Installers, LLC
556 N. Route 17
Paramus, NJ
Ekla Elizabeth Kennedy Landscape Architects
(718)596-8837
Navy Yard
Brooklyn, NY
Riverdale Tree Service
(718)543-2475
Po Box 194
Bronx, NY
Atlas & Design Contractors Inc.
(212)289-1189
315 East 86th Street
New York, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor

Related Articles