Handling Siding Materials Yonkers NY

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid.

Local Companies

Craig Custom Builders
144 Osceola Rd
Wayne, NJ
SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Franzoso Contracting
33 Croton Point Ave.
Croton-on-Hudson, NY
Design Lighting by Marks
(914)747-7777
5 Nepperhan Avenue
Elmsford, NY
West Gate Landscaping Inc
(845)357-9581
166 Route 59
Suffern, NY
Len Van Builders
31 Stalter Drive
Wayne, NJ
G&L and Sons Renovations
153 Young Ave.
Cedar Grove, NJ
Paragon Installers, LLC
556 N. Route 17
Paramus, NJ
Garden Works
(718)539-2986
43-35 157th St
Flushing, NY
Independent Landscaping
(718)225-3136
25017 Rushmore Terrace
Little Neck, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: September 1, 2005

By Carl Sperry

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid:

Improper fastening. By far the most common error. Most manufacturers recommend setting your nails flush with the surface of the piece and snug to the wall. “I've seen brand new, blind-nailed sided houses where you could pull the siding off with two fingers,” says Mark Parlee, owner of Parlee Builders, in Des Moines, Iowa. Eliminate this by using the proper nail gun; that is, one with a depth-of-drive adjustment. Turning down the compression will also help, but it may not be enough. Another option is to hand-nail or screw the pieces on. Both will increase labor burden but help you avoid this mistake.

Fitting pieces too tightly to trim or to each other. This may seem like a good idea, but it often results in the piece(s) bowing during expansion, causing unsightly waves. It's especially noticeable on long straight walls. Avoid it by leaving a 1/16- to 1/8-inch gap where the siding butts the trim and apply high-quality sealant to the gap. This will allow the siding to expand and contract without bowing.

Not nailing on the studs. A huge no-no. Fiber-cement siding is heavy (2.2 pounds per foot). Not hitting the studs is a recipe for disaster in high-wind areas.

Click here to read full article from Replacement Contractor

Related Articles
- Heavy Lifters Yonkers NY
Toyota Material Handling now offers a factory-installed compressed natural gas (CNG) fuel system on its 4,000- to 6,500-pound-capacity internal combustion (IC) cushion tire and 3,000- to 6,500-pound-capacity IC pneumatic lift truck models.
- Flashing in Siding Installations Yonkers NY
- Exterior Products Yonkers NY
- Forklift Maintenance Tips Yonkers NY
- Home Siding Tips Yonkers NY
- Exterior Siding Products Yonkers NY
- Home Exterior Products Yonkers NY
- Innovative Products for Home Remodeling Projects Yonkers NY
- Growing Your Business Yonkers NY
- Fan-Fold Foam Board Yonkers NY