Handling Siding Materials Fredonia NY

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid.

Local Companies

Rodgers & Son Inc
(716)296-8065
7406 North Route 83
Cherry Creek, NY
Nyberg Landscaping
(716)753-2918
4927 Potter Road
Mayville, NY
Storer Excavating & Trucking
(716)595-3186
7534 Route 380
Stockton, NY
Misty Ridge Landscaping LLP
(716)326-4765
6548 Portage Road
Westfield, NY
Don Lane
Lane TV & Satellite

716-962-9401
6073 - 6081 Route 380
Sinclairville, NY
Gugino Lawn & Garden
(716)549-1414
Brant Reservation Road
Brant, NY
Erie Landscaping
(716)988-3672
8961 South Dayton Silver Creek
Forestville, NY
R & R Landscaping
(716)753-2787
136 South Erie Street
Mayville, NY
KUTZ John E Nursery
(716)326-3006
21 North Water Street
Westfield, NY
Westfield Nursery & Garden Shop
(716)326-3032
West Main Road
Westfield, NY

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: September 1, 2005

By Carl Sperry

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid:

Improper fastening. By far the most common error. Most manufacturers recommend setting your nails flush with the surface of the piece and snug to the wall. “I've seen brand new, blind-nailed sided houses where you could pull the siding off with two fingers,” says Mark Parlee, owner of Parlee Builders, in Des Moines, Iowa. Eliminate this by using the proper nail gun; that is, one with a depth-of-drive adjustment. Turning down the compression will also help, but it may not be enough. Another option is to hand-nail or screw the pieces on. Both will increase labor burden but help you avoid this mistake.

Fitting pieces too tightly to trim or to each other. This may seem like a good idea, but it often results in the piece(s) bowing during expansion, causing unsightly waves. It's especially noticeable on long straight walls. Avoid it by leaving a 1/16- to 1/8-inch gap where the siding butts the trim and apply high-quality sealant to the gap. This will allow the siding to expand and contract without bowing.

Not nailing on the studs. A huge no-no. Fiber-cement siding is heavy (2.2 pounds per foot). Not hitting the studs is a recipe for disaster in high-wind areas.

Click here to read full article from Replacement Contractor