Handling Siding Materials Farmingdale NY

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid.

Local Companies

Kuhn Construction, Inc
417 Main St
Islip, NY
Coastal Landscaping & Design
(631)587-0436
129 South Penataquit Avenue
Bay Shore, NY
E J Irrigation
(631)421-2422
18 Cortelyou Street East
Huntington Station, NY
Pioneer Landscaping & Asphalt Paving Inc
(631)269-4300
20 Old Northport Road
Kings Park, NY
Edwin Chiong
C+C Design Group, Inc.

(516) 808-1924
44 Terrehans Lane
Syosset, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
Legacy Builders and Remodelers
1363-8 Lincoln Ave
Holbrook, NY
Custom Lawn Care Inc
(631)467-5900
321 Dante Court
Holbrook, NY
Bosco Tony Landscaping Design Builder
(631)425-2917
865 Park Avenue
Huntington, NY
C K Landscaping
(631)261-7347
9 Bruce Lane
Northport, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: September 1, 2005

By Carl Sperry

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid:

Improper fastening. By far the most common error. Most manufacturers recommend setting your nails flush with the surface of the piece and snug to the wall. “I've seen brand new, blind-nailed sided houses where you could pull the siding off with two fingers,” says Mark Parlee, owner of Parlee Builders, in Des Moines, Iowa. Eliminate this by using the proper nail gun; that is, one with a depth-of-drive adjustment. Turning down the compression will also help, but it may not be enough. Another option is to hand-nail or screw the pieces on. Both will increase labor burden but help you avoid this mistake.

Fitting pieces too tightly to trim or to each other. This may seem like a good idea, but it often results in the piece(s) bowing during expansion, causing unsightly waves. It's especially noticeable on long straight walls. Avoid it by leaving a 1/16- to 1/8-inch gap where the siding butts the trim and apply high-quality sealant to the gap. This will allow the siding to expand and contract without bowing.

Not nailing on the studs. A huge no-no. Fiber-cement siding is heavy (2.2 pounds per foot). Not hitting the studs is a recipe for disaster in high-wind areas.

Click here to read full article from Replacement Contractor

Related Articles