Handling Siding Materials East Setauket NY

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid.

Local Companies

Legacy Builders and Remodelers
1363-8 Lincoln Ave
Holbrook, NY
Benedetto Bros Landscaping
(631)242-0262
P O Box 239
Deer Park, NY
Village Power Tool Inc
(516)421-5020
139 New York Ave
Huntington, NY
Conserv-A-Tree
(631)271-2998
282 Bway
Huntington Station, NY
Stang Landscaping Corporation
(631)567-7792
204 North Main Street
Sayville, NY
Kuhn Construction, Inc
417 Main St
Islip, NY
Bellport Land Material Inc
(631)776-1684
1795 Montauk Highway
Bellport, NY
John Patrick Triandafils Landscape
(631)473-6001
7 Pheasant Lane
East Setauket, NY
Aliperti Lawn Maintenance & Masonry
(631)271-0413
215 Crombie Street
Huntington Station, NY
Valente Landscaping Inc
(631)654-5119
690 Old Medford Avenue
Medford, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: September 1, 2005

By Carl Sperry

Like all siding materials, fiber cement has a learning curve. With a few simple steps, however, you can achieve excellent results on a consistent basis. Here are the biggest mistakes to avoid:

Improper fastening. By far the most common error. Most manufacturers recommend setting your nails flush with the surface of the piece and snug to the wall. “I've seen brand new, blind-nailed sided houses where you could pull the siding off with two fingers,” says Mark Parlee, owner of Parlee Builders, in Des Moines, Iowa. Eliminate this by using the proper nail gun; that is, one with a depth-of-drive adjustment. Turning down the compression will also help, but it may not be enough. Another option is to hand-nail or screw the pieces on. Both will increase labor burden but help you avoid this mistake.

Fitting pieces too tightly to trim or to each other. This may seem like a good idea, but it often results in the piece(s) bowing during expansion, causing unsightly waves. It's especially noticeable on long straight walls. Avoid it by leaving a 1/16- to 1/8-inch gap where the siding butts the trim and apply high-quality sealant to the gap. This will allow the siding to expand and contract without bowing.

Not nailing on the studs. A huge no-no. Fiber-cement siding is heavy (2.2 pounds per foot). Not hitting the studs is a recipe for disaster in high-wind areas.

Click here to read full article from Replacement Contractor

Related Articles