Foolproof Layout Method Plans Richmond Hill NY

When framing walls in Richmond Hill, pull all layout measurements from the same control point, and always move in the same direction, for example, start at the front of the building and always move left to right.

Local Companies

Amber Freda Landscape Design
646-546-1592
Ny
Ny, NY
Ny Landscape Lighting
914-523-2578
245 Bronx River Road 3B
Yonkers, NY
Urban Plantscapes
(212) 351-5094
1607 Clinton Street
Hoboken, NJ
Judith Heintz Landscape Architect
(212) 274-8599
307 Canal St Apt 4s
New York, NY
Manny's Landscaping Corporation
(718) 727-5737
119 Dubois Ave
saintaten Island, NY
A Palmieri Landscaping Company, Inc
914-699-2257
6 Penn Place
Pelham Manor, NY
Light Scaping Concepts Inc
917-599-7139 / 917-599-7901
65-23 Claran Ct
Maspeth, NY
Sustain Landscape Design
(718) 395-3567
300 Stuyvesant Avenue
Brooklyn, NY
Ken Smith Landscape Architect
(212) 791-3595
79 Chambers St Fl 2
New York, NY
Benitez Landscape & Design
(631) 736-5937
25 Pine St
New York, NY
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 1, 2003

By Steve Veroneau

Picture these scenarios: You've agonized to measure, double-check, and line up a complicated roofline, but after nailing up the rafters, you notice that the fascia lines are out of whack. Or, you've cut out all of your tair stringers, only to realize they don't fit and now you're racing rush-hour traffic to the lumberyard. Here are a few layout methods with built-in double-checks that can help solve problems before they start.

Layout Direction. When framing walls, pull all layout measurements from the same control point, and always move in the same direction, for example, start at the front of the building and always move left to right. The direction doesn't matter as long as it's the same throughout the building, including the second and third floors. Consistent layout direction ensures that studs, rafters, and joists align throughout construction. This makes life easier for installing duct work, pipes, or conduit later, leaving any bay useable as a chase throughout the structure.

Repeating Wall Patterns. Plate and detail any lined-up, same-dimension walls at the same time, so you only pull your tape once for multiple walls. For example, architects often load long hallways with closets that are usually the same size; cutting them and laying them out in one shot is easier, more accurate, and faster than laying them out as you go. It's also common to see repeating wall patter...

Click here to read full article from Tools of the Trade

Related Articles
- Framing Gable and Shed Dormers Richmond Hill NY
Whenever adding any type of dormer, it's essential to determine the roof load and design the load path transfer to the existing floor joists or roof rafters. Then you can ensure adequate bearing points, or add framing and install beams to carry the loads through the walls down to the foundation. It wouldn't be a bad idea to consult a structural engineer for guidance, especially on larger dormers.
- Eliminating Swirls in Precast Panels Richmond Hill NY
- Framing Square Richmond Hill NY
- Hidden-Fastener Tool Richmond Hill NY
- How Masonry Buildings Resist Earthquakes Richmond Hill NY
- Framer's Guide to Engineered Lumber Richmond Hill NY