Foolproof Layout Method Plans Huntington NY

When framing walls in Huntington, pull all layout measurements from the same control point, and always move in the same direction, for example, start at the front of the building and always move left to right.

Local Companies

Jordan P. Grant, Inc.
(203) 854-4949
377 Highland Avenue
Norwalk, CT
Park Landscape Design Group, LLC
(203) 662-0000
22 Thorndal Circle
Darien, CT
Landscape Design By Lee
(631) 589-0076
Sayville Boulevard
Sayville, NY
Hickory Landscaping
203-838-1119
5 Pogany Street
Norwalk, CT
Landscapes By Lee Itzler
631-368-8626
486 Elwood Road
East Northport, NY
Long Island landscping Ltd.
800-986-9520
36 Lincoln Ave.
Bay Shore, NY
Greg Twardy Jr. Landscape Contractors
(203) 655-1015
49 Herman Avenue
Darien, CT
Jordan P. Grant, Inc.
(203) 854-4949
Darien, CT
Morell Landscape Associates
516-338-9095
150H School St.
westbury, NY
Land Masters
(203) 210-7201
1117 East Putnam Avenue
Riverside, CT
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 1, 2003

By Steve Veroneau

Picture these scenarios: You've agonized to measure, double-check, and line up a complicated roofline, but after nailing up the rafters, you notice that the fascia lines are out of whack. Or, you've cut out all of your tair stringers, only to realize they don't fit and now you're racing rush-hour traffic to the lumberyard. Here are a few layout methods with built-in double-checks that can help solve problems before they start.

Layout Direction. When framing walls, pull all layout measurements from the same control point, and always move in the same direction, for example, start at the front of the building and always move left to right. The direction doesn't matter as long as it's the same throughout the building, including the second and third floors. Consistent layout direction ensures that studs, rafters, and joists align throughout construction. This makes life easier for installing duct work, pipes, or conduit later, leaving any bay useable as a chase throughout the structure.

Repeating Wall Patterns. Plate and detail any lined-up, same-dimension walls at the same time, so you only pull your tape once for multiple walls. For example, architects often load long hallways with closets that are usually the same size; cutting them and laying them out in one shot is easier, more accurate, and faster than laying them out as you go. It's also common to see repeating wall patter...

Click here to read full article from Tools of the Trade

Related Articles
- Framing Gable and Shed Dormers Huntington NY
Whenever adding any type of dormer, it's essential to determine the roof load and design the load path transfer to the existing floor joists or roof rafters. Then you can ensure adequate bearing points, or add framing and install beams to carry the loads through the walls down to the foundation. It wouldn't be a bad idea to consult a structural engineer for guidance, especially on larger dormers.
- Hidden-Fastener Tool Huntington NY
- How Masonry Buildings Resist Earthquakes Huntington NY
- Eliminating Swirls in Precast Panels Huntington NY
- Framing Square Huntington NY
- Framer's Guide to Engineered Lumber Huntington NY