Flashing in Siding Installations Yonkers NY

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic.

Local Companies

Craig Custom Builders
144 Osceola Rd
Wayne, NJ
SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Franzoso Contracting
33 Croton Point Ave.
Croton-on-Hudson, NY
J & M Landscapers
(914)476-6677
32 McGeory Avenue
Bronxville, NY
Marenco Lawn Sprinkler CO
(914)235-0068
36 Church Street
New Rochelle, NY
Len Van Builders
31 Stalter Drive
Wayne, NJ
G&L and Sons Renovations
153 Young Ave.
Cedar Grove, NJ
Paragon Installers, LLC
556 N. Route 17
Paramus, NJ
Gramtan Gardens
(914)779-5529
48 Sagamore Rd
Bronxville, NY
Rolling Acres Lawns & Landscaping
(845)638-4420
349 Phillips Hill Road
New City, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor

Related Articles
- Flashing at Sills Yonkers NY
Sill flashing controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill.
- Growing Your Business Yonkers NY
- Exterior Siding Products Yonkers NY
- Fan-Fold Foam Board Yonkers NY
- Inner Corner at Base of Wall Yonkers NY
- Handling Siding Materials Yonkers NY
- Home Siding Tips Yonkers NY
- Flashing Factors Yonkers NY
- Flashing and Sill Products Yonkers NY
- Innovative Products for Home Remodeling Projects Yonkers NY