Flashing in Siding Installations South Richmond Hill NY

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic.

Local Companies

SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Control Enviromental Services
(516)222-2079
1 Education Drive
Garden City, NY
Oceanville Mason Supply CO Inc
(516)678-1523
2499 Long Beach Road
Oceanside, NY
Tips Florist
(914)738-6060
85 Lincoln Avenue
Pelham, NY
Bil-Ro Landscaping
(516)997-6794
100 Jericho Turnpike
Westbury, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
Marra Angelo Landscaping
(718)837-0318
2136 83rd Street
Brooklyn, NY
Ziminski Nursery
(516)826-4986
998 Old Britton Road
North Bellmore, NY
Max Gordon & Associates- Architects
(212)689-8000
270 Madison Avenue
New York, NY
County Wide Landscaping & Maintenance
(516)766-0756
164 South Centre Avenue
Rockville Centre, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor