Flashing in Siding Installations Queens Village NY

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic.

Local Companies

SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Riverdale Florist
(718)548-4226
210 West 231st Street
Bronx, NY
Instant Aqua Systems
(914)777-1553
1619 Winfield Avenue
Mamaroneck, NY
Jason Brand
East Coast Cleaning & Restoration LLC

718-292-3299
1735 West Farms Road
Bronx, NY
Frank Oliveri
Frank"s Painting

516-924-5398
7 Gingham Ln.
Levittown, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
G & D Landscape Corporation
(718)256-7600
2139 57th Street
Brooklyn, NY
Smith BROS Plumbing CO
(718)471-4646
698 Beach 20th Street
Far Rockaway, NY
Marmo Arredo Usa
(212)447-9369
200 Lexington Ave
New York, NY
Mike
Good Guys Electric, Inc

516 221-9111
3698 Locust Ave
Seaford, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor