Flashing in Siding Installations East Elmhurst NY

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic.

Local Companies

SilverLining Interiors, Inc.
2091 Broadway, third floor
New York, NY
Dominick Commisso Corporation
(516)735-3519
39 Stewart Avenue
Bethpage, NY
Auxin Contrctng & Landscaping CO
(516)731-0202
2452 2nd Street
East Meadow, NY
Woodland Nursery & Landscaping
(516)596-4382
131 Franklin Ave
Malverne, NY
D & D Garden Center
(914)969-3785
30 Clement
Yonkers, NY
Alure Home Improvements
1999 Hempstead Turnpike
East Meadow, NY
Paragon Installers, LLC
556 N. Route 17
Paramus, NJ
Lawrence J Lapide Inc
(718)763-3665
Brooklyn Terminal Market
Brooklyn, NY
Great Outdoors Landscaping
(516)546-3117
61 Walnut Rd
Inwood, NY
Greenview Nursery
(516)481-4836
547 Maude Street
South Hempstead, NY
Data Provided by:
  

Provided By:

Source: REPLACEMENT CONTRACTOR Magazine
Publication date: November 1, 2005

By Carl Sperry

A constant problem that contractors see in siding installations is improper flashing or, even worse, no flashing at all. Relying on caulk alone to keep water from leaking into homes is not a good practice. Whether you're talking about wood, fiber-cement, or vinyl siding, three areas in particular can prove problematic:

Above door and window headers.

After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose. Flashing has to be intact to do its job, which is to keep water from contact with the wall. That goes for the weather barrier as well. Run the weather barrier over the flashing so that water doesn't get behind it. You want water to run over, not under, the siding.

Inside corners.

Tough and tricky, because sometimes your weather barrier gets torn trying to fit it into corners at a 90-degree angle. A simple fix for this is bending flashing in an L-shape before installing it in the corner. Then, after flashing is installed, run weather barrier over the flashing to eliminate the worry of tearing the paper and getting a leak.

Roofs and walls.

Another overlooked detail is where roofs intersect walls. Relying on step flashing alone is usually not enough.

Click here to read full article from Replacement Contractor