Flashing at Sills Roosevelt NY

Sill flashing in Roosevelt controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill.

Local Companies

Illuminetrix, Inc
516-798-1309
87 Pennsylvania Avenue
Massapequa, NY
Renaissance Electric Corp
(718) 515-2853
4039 Laconia Ave
Bronx, NY
WAC Lighting
1.800.526.2588
615 South Street
Garden City, NY
Business Automation Services
(518) 371-6869
636 Plank Rd Ste 207
Clifton Park, NY
Technology Access Service Corporation
(631) 654-5080
2690 Route 112
Medford, NY
Solar Energy Systems, Inc.
(718) 389-1545
1205 Manhattan Avenue
New York, NY
RBK NEW YORK CORP
(516) 825-3268
29 Aberdeen Street
Malverne, NY
Illuminations
516-766-4880
251 Sunrise Highway
Rockville Centre, NY
Keller & Vandernoth Inc
(212) 741-0202
1133 Broadway
New York, NY
Grenell Consulting Group
(585) 292-9540
496 White Spruce Blvd
Rochester, NY

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: July 1, 2000

Why do people install flashings beneath masonry sills? Are they required if a single-piece stone sill is used?

Sill flashing controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill. These flashings are especially important when using rowlock brick sills or other sills that have many joints. Multiple joints increase the risk of developing excessive water penetration into the masonry below.

In hot humid climates, sill flashings may also be helpful in preventing hot humid cavity air from condensing on the underside and perimeter of the window. In this case, the sill flashings should be integrated with a cavity seal at the window head and jambs.

When using a single-piece stone or precast concrete at a window, the flashing is less important. Very little water will penetrate a single-piece stone or concrete sill. Flashings, however, are still useful in controlling water penetration at perimeter sealant joints or preventing hot humid cavity air from reaching the perimeter of the window. Where flashing is not used, the stone or precast concrete sill should project beyond the face of the masonry and contain a drip. This will prevent water penetration at the joint beneath the sill. This joint will often crack due to differential m...

Click here to read full article from Masonry Construction

Related Articles
- Home Siding Tips Roosevelt NY
After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.
- High-Efficiency Products Roosevelt NY
- Home Exterior Products Roosevelt NY
- Flashing Factors Roosevelt NY
- Eco-Friendly Products Roosevelt NY
- Flashing in Siding Installations Roosevelt NY
- Inner Corner at Base of Wall Roosevelt NY
- Flashing and Sill Products Roosevelt NY