Flashing at Sills Ogdensburg NY

Sill flashing in Ogdensburg controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill.

Local Companies

Corporate Center
(315) 393-3793
812 Proctor Ave
Ogdensburg, NY
Paxos Lucy
(718) 295-5471
2653 Jerome Ave
Bronx, NY
Pencom Consulting
(212) 513-1801
40 Fulton St Fl 28
New York, NY
Hedria Consulting
(585) 586-5710
11 Circle Wood Rd
East Rochester, NY
Merendino Corp
(516) 678-0624
70 New St
Oceanside, NY
Coleman and Associates
(315) 394-0295
7814 State Highway 68
Ogdensburg, NY
C Vjs Management Corp
(516) 795-5143

Massapequa, NY
Riverside Management Services Organization
(914) 674-0029
20 Beacon Hill Dr
Dobbs Ferry, NY
Ecosys Management Llc
(212) 742-0770
55 Broad St
New York, NY
Enterprise Solutions Inc
(585) 241-2090
706 East Ave
Rochester, NY

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: July 1, 2000

Why do people install flashings beneath masonry sills? Are they required if a single-piece stone sill is used?

Sill flashing controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill. These flashings are especially important when using rowlock brick sills or other sills that have many joints. Multiple joints increase the risk of developing excessive water penetration into the masonry below.

In hot humid climates, sill flashings may also be helpful in preventing hot humid cavity air from condensing on the underside and perimeter of the window. In this case, the sill flashings should be integrated with a cavity seal at the window head and jambs.

When using a single-piece stone or precast concrete at a window, the flashing is less important. Very little water will penetrate a single-piece stone or concrete sill. Flashings, however, are still useful in controlling water penetration at perimeter sealant joints or preventing hot humid cavity air from reaching the perimeter of the window. Where flashing is not used, the stone or precast concrete sill should project beyond the face of the masonry and contain a drip. This will prevent water penetration at the joint beneath the sill. This joint will often crack due to differential m...

Click here to read full article from Masonry Construction

Related Articles
- Home Siding Tips Ogdensburg NY
After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.
- Flashing in Siding Installations Ogdensburg NY
- High-Efficiency Products Ogdensburg NY
- Home Exterior Products Ogdensburg NY
- Eco-Friendly Products Ogdensburg NY
- Flashing Factors Ogdensburg NY
- Inner Corner at Base of Wall Ogdensburg NY
- Flashing and Sill Products Ogdensburg NY