Flashing at Sills Mount Vernon NY

Sill flashing in Mount Vernon controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill.

Local Companies

Calger Lighting Incorporated
(212) 689-9511
200 Lexington Ave
New York, NY
East Coast Lighting Incorporated
(212) 643-9727
353 W 39th St
New York, NY
Lendy Electric Equipment & Supply Corporation
(212) 941-1334
176 Grand St
New York, NY
Himalayan Lights
(212) 877-2159
200 W. 86th Street
New York, NY
Enhanced Home
914-560-4100
163 North Main Street
Port Chester, NY
Brady Susan Lighting Design
(212) 391-4230
39 W 38th St
New York, NY
Columbia Interiors Incorporated
(212) 725-5250
200 E 33rd St
New York, NY
Emporium Antique Shop Limited
(212) 724-9521
20 W 64th St
New York, NY
Argo International
(212) 431-1700
140 Franklin Street
New York, NY
Weiss & Biheller
(212) 979-6990
440 Nepperhan Avenue
Yonkers, NY

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: July 1, 2000

Why do people install flashings beneath masonry sills? Are they required if a single-piece stone sill is used?

Sill flashing controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill. These flashings are especially important when using rowlock brick sills or other sills that have many joints. Multiple joints increase the risk of developing excessive water penetration into the masonry below.

In hot humid climates, sill flashings may also be helpful in preventing hot humid cavity air from condensing on the underside and perimeter of the window. In this case, the sill flashings should be integrated with a cavity seal at the window head and jambs.

When using a single-piece stone or precast concrete at a window, the flashing is less important. Very little water will penetrate a single-piece stone or concrete sill. Flashings, however, are still useful in controlling water penetration at perimeter sealant joints or preventing hot humid cavity air from reaching the perimeter of the window. Where flashing is not used, the stone or precast concrete sill should project beyond the face of the masonry and contain a drip. This will prevent water penetration at the joint beneath the sill. This joint will often crack due to differential m...

Click here to read full article from Masonry Construction

Related Articles
- Home Siding Tips Mount Vernon NY
After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.
- Home Exterior Products Mount Vernon NY
- Flashing and Sill Products Mount Vernon NY
- High-Efficiency Products Mount Vernon NY
- Flashing in Siding Installations Mount Vernon NY
- Flashing Factors Mount Vernon NY
- Eco-Friendly Products Mount Vernon NY
- Inner Corner at Base of Wall Mount Vernon NY