Flashing at Sills East Setauket NY

Sill flashing in East Setauket controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill.

Local Companies

Palmedo Assoc
(631) 751-2474
100 N Country Rd
East Setauket, NY
T W R Express
(718) 472-5859
3830 Crescent St
Long Island City, NY
R & R Management Corp
(718) 804-9354
366 Decatur St
Brooklyn, NY
Wealthcare Center of Guilderland
(518) 452-9922
2050 Western Ave
Guilderland, NY
Kriesel Co Inc
(718) 241-4929
1755 Utica Ave
Brooklyn, NY
Arain Enterprises Inc
(631) 689-3021
210 N Belle Mead Rd
East Setauket, NY
McCormick Mngmnt Consulting
(845) 485-1502
41 Page Park Dr
Poughkeepsie, NY
A O R Management Co of Ny
(518) 373-3800
5 Old Route 146
Clifton Park, NY
Bushwick Community Svc Society
(718) 573-3358
1639 Broadway
Brooklyn, NY
Towers Perrin
(914) 747-5962
100 Summit Lake Dr Ste 204
Valhalla, NY

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: July 1, 2000

Why do people install flashings beneath masonry sills? Are they required if a single-piece stone sill is used?

Sill flashing controls water that penetrates through the masonry sill and helps control water penetrating the perimeter sealant joint around the windows. The sill flashing will prevent water from saturating the top of the masonry beneath the sill. These flashings are especially important when using rowlock brick sills or other sills that have many joints. Multiple joints increase the risk of developing excessive water penetration into the masonry below.

In hot humid climates, sill flashings may also be helpful in preventing hot humid cavity air from condensing on the underside and perimeter of the window. In this case, the sill flashings should be integrated with a cavity seal at the window head and jambs.

When using a single-piece stone or precast concrete at a window, the flashing is less important. Very little water will penetrate a single-piece stone or concrete sill. Flashings, however, are still useful in controlling water penetration at perimeter sealant joints or preventing hot humid cavity air from reaching the perimeter of the window. Where flashing is not used, the stone or precast concrete sill should project beyond the face of the masonry and contain a drip. This will prevent water penetration at the joint beneath the sill. This joint will often crack due to differential m...

Click here to read full article from Masonry Construction

Related Articles
- Home Siding Tips East Setauket NY
After installing window and door trim, either make flashing using a sheet metal brake or apply flashing pre-bent to the correct trim size. Nail your flashing to the wall, not to the trim, because if you put holes in the flashing, you've defeated its purpose.
- Home Exterior Products East Setauket NY
- Flashing in Siding Installations East Setauket NY
- Flashing and Sill Products East Setauket NY
- Inner Corner at Base of Wall East Setauket NY
- Eco-Friendly Products East Setauket NY
- High-Efficiency Products East Setauket NY
- Flashing Factors East Setauket NY