First Test: T-Drill T-35 Tee-Forming Tool West Babylon NY

A T-Drill is a unique, incredible plumber's tool in West Babylon that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

Local Companies

Roberts Plywood Co.
800-422-4944
45 North Industry Court
Deer Park, NY
Costello's Ace Hardware
(516) 280-7885
2323 Jericho Turnpike, In Pathmark Shopping Center/Near Charlie Brown's
Garden City Park, NY
DYNAMITE TOOL CO
(631) 563-8181
1551 SMITHTOWN AVENUE BOHEMIA, NY, 11716
Bohemia, NY
Ace Hardware of Commack
(631) 670-6540
2160B Jericho Tpke.
Commack, NY
The Home Depot
(631)493-2320
65 Crooked Hill Road
Commack, NY
EXOTIC WOODS USA
(631) 651-8651
698 Fort Salonga Rd
Northport, NY
Suburban Mills
631-351-6445
16 Railroad St
Huntington Station, NY
Lowe's
(631) 954-9001
800 Sunrise Highway
Bay Shore, NY
Fastenal- Hicksville
516-942-2640
73 Bloomingdale Rd Hicksville, NY, 11801
Hicksville, NY
Islip True Value Hardware
(631) 581-0951
445 Main St
Islip, NY
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: September 12, 2007

By Michael Springer

A T-Drill is a unique, incredible plumber's tool that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

A T-Drill pulls a tee out of a continuous run of copper tubing. It consists of a drill motor with a high-tech business end that does the holding, drilling, and forming. Here's how it works: support legs at the head of the drill hold it centered on a piece of tubing. With the desired outlet-size T-Drill head attached, a pilot hole is drilled into the tube; then, with the bit still in the tube, two forming pins built into the pilot bit are extended by rotating a collar on the head.

After engaging the reverse-feed mechanism lever, the support legs push against the tubing, and the spinning forming pins back out of the tube, leaving a tee outlet of the proper size. And all of this is done in mere seconds.

Then the branch, or outlet, section of tubing is prepared by placing it in a T-Drill notcher, where it is cut to the sameradius as the tube run so the branch does not project into the run of tube. The notcher also leaves two dimples on the branch. These serve as a depth stop, an alignment guide, and provide for easy inspection of the joint.

Click here to read full article from Tools of the Trade

Related Articles