First Test: T-Drill T-35 Tee-Forming Tool South Richmond Hill NY

A T-Drill is a unique, incredible plumber's tool in South Richmond Hill that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

Local Companies

Sunset Hardware
(718) 748-0960
8111 5th Ave
Brooklyn, NY
Herman's Has Everything
800-273-4376
1070 Linwood Street Brooklyn, NY, 11208
Brooklyn, NY
Modern Paint & Hardware Corp
914-632-8060
316 Huguenot St
New Rochelle, NY
The Home Depot
(973)848-0600
399-443 Springfield Ave
Newark, NJ
Kings Plz
(718) 677-2100
5200 Kings Plz
Brooklyn, NY
Monster Woodshop
888-506-6678
607 18th Street
Brooklyn, NY
GENERAL MACHINERY INC
(212) 226-7835
358 BROOME STREET NEW YORK, NY, 10013
New York, NY
Brickman Outlets Inc
(212) 777-1500
125 W 3rd St, The Blue Note
New York, NY
Kings Material Company Inc.
718-438-5232
3707 15th Avenue
Brooklyn, NY
Newport Centre Mall
(201) 420-5300
50 Mall Dr West
Jersey City, NJ
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: September 12, 2007

By Michael Springer

A T-Drill is a unique, incredible plumber's tool that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

A T-Drill pulls a tee out of a continuous run of copper tubing. It consists of a drill motor with a high-tech business end that does the holding, drilling, and forming. Here's how it works: support legs at the head of the drill hold it centered on a piece of tubing. With the desired outlet-size T-Drill head attached, a pilot hole is drilled into the tube; then, with the bit still in the tube, two forming pins built into the pilot bit are extended by rotating a collar on the head.

After engaging the reverse-feed mechanism lever, the support legs push against the tubing, and the spinning forming pins back out of the tube, leaving a tee outlet of the proper size. And all of this is done in mere seconds.

Then the branch, or outlet, section of tubing is prepared by placing it in a T-Drill notcher, where it is cut to the sameradius as the tube run so the branch does not project into the run of tube. The notcher also leaves two dimples on the branch. These serve as a depth stop, an alignment guide, and provide for easy inspection of the joint.

Click here to read full article from Tools of the Trade