First Test: T-Drill T-35 Tee-Forming Tool Rockville Centre NY

A T-Drill is a unique, incredible plumber's tool in Rockville Centre that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

Local Companies

Roberts Plywood Co.
800-422-4944
45 North Industry Court
Deer Park, NY
Costello's Ace Hardware
(631) 422-5566
448 Union Blvd
West Islip, NY
Tonys Hardware & Tool Rental
12414 Liberty Ave
S Richmond Hill, NY
Trio Hardware
516-935-8385
1032 C Old Country Rd
Plainview, NY
Lake Success S/C
(516) 574-5500
1400 Union Tpke
New Hyde Park, NY
Monster Woodshop
888-506-6678
607 18th Street
Brooklyn, NY
Suburban Mills
631-351-6445
16 Railroad St
Huntington Station, NY
A G Locksmith & Hardware
(718) 497-5882
347 Knickerbocker Ave
Brooklyn, NY
Five Star Lumber & Home Ctrs
516-872-2700
210 E Merrick Rd
Valley Stream, NY
The Home Depot
(718)832-8553
550 Hamilton Ave
Brooklyn, NY
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: September 12, 2007

By Michael Springer

A T-Drill is a unique, incredible plumber's tool that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

A T-Drill pulls a tee out of a continuous run of copper tubing. It consists of a drill motor with a high-tech business end that does the holding, drilling, and forming. Here's how it works: support legs at the head of the drill hold it centered on a piece of tubing. With the desired outlet-size T-Drill head attached, a pilot hole is drilled into the tube; then, with the bit still in the tube, two forming pins built into the pilot bit are extended by rotating a collar on the head.

After engaging the reverse-feed mechanism lever, the support legs push against the tubing, and the spinning forming pins back out of the tube, leaving a tee outlet of the proper size. And all of this is done in mere seconds.

Then the branch, or outlet, section of tubing is prepared by placing it in a T-Drill notcher, where it is cut to the sameradius as the tube run so the branch does not project into the run of tube. The notcher also leaves two dimples on the branch. These serve as a depth stop, an alignment guide, and provide for easy inspection of the joint.

Click here to read full article from Tools of the Trade

Related Articles
- Hitachi KM 12VC Router Combination Kit Rockville Centre NY
Sometimes combination tools have to make too many compromises to perform their numerous functions. Fortunately, that's not the case with Hitachi's new KM 12VC router combination kit. This smartly designed, solidly constructed, and well-outfitted tool fulfills its promises as a fixed-base and plunge-base router. And, at $180 you've got a tool that pulls its weight without asking much in return.
- Framing Square Rockville Centre NY
- Festool C12 Cordless Drill Rockville Centre NY
- Home Repair Tools Rockville Centre NY
- Hidden-Fastener Tool Rockville Centre NY
- Hand Tools Rockville Centre NY
- Drywall Cutting and Multifunction Bench Rockville Centre NY
- INNOVA® 3100 Tools Rockville Centre NY
- Festool Joining System Rockville Centre NY
- Graphisoft EcoDesigner Rockville Centre NY