First Test: T-Drill T-35 Tee-Forming Tool Fredonia NY

A T-Drill is a unique, incredible plumber's tool in Fredonia that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

Local Companies

Valu Home Center #20
716-673-1771
10378 Bennett Rd
Fredonia, NY
Frost Builders Supplies, Inc.
716-296-5695
Depot Street
Cherry Creek, NY
Service Hardware True Value
(716) 366-5666
234 Lake Shore Dr E
Dunkirk, NY
Smiths True Value
(716) 934-4238
Route 5 & 20
Irving, NY
Fredonia - Auth Hometown
(716) 672-2999
3725 E Main - Rte 20
Fredonia, NY
Fastenal- Dunkirk
716-366-3595
61-63 Lakeshore Dr Dunkirk, NY, 14048
Dunkirk, NY
Valley Hardware Center
716-988-3304
524 Pine Street
South Dayton, NY
Mayville Hardware Inc
716-753-2621
53 South Erie Street
Mayville, NY
Add Lumber True Value
(716) 366-1622
148 Willow Rd
Dunkirk, NY
The Home Depot
(716)672-8200
3901 Vineyard Drive
Dunkirk, NY

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: September 12, 2007

By Michael Springer

A T-Drill is a unique, incredible plumber's tool that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

A T-Drill pulls a tee out of a continuous run of copper tubing. It consists of a drill motor with a high-tech business end that does the holding, drilling, and forming. Here's how it works: support legs at the head of the drill hold it centered on a piece of tubing. With the desired outlet-size T-Drill head attached, a pilot hole is drilled into the tube; then, with the bit still in the tube, two forming pins built into the pilot bit are extended by rotating a collar on the head.

After engaging the reverse-feed mechanism lever, the support legs push against the tubing, and the spinning forming pins back out of the tube, leaving a tee outlet of the proper size. And all of this is done in mere seconds.

Then the branch, or outlet, section of tubing is prepared by placing it in a T-Drill notcher, where it is cut to the sameradius as the tube run so the branch does not project into the run of tube. The notcher also leaves two dimples on the branch. These serve as a depth stop, an alignment guide, and provide for easy inspection of the joint.

Click here to read full article from Tools of the Trade

Related Articles