First Test: T-Drill T-35 Tee-Forming Tool Depew NY

A T-Drill is a unique, incredible plumber's tool in Depew that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

Local Companies

Certainly Wood, Inc.
716-655-0206
13000 Route 78
East Aurora, NY
RC Tonewoods
716-873-6043
1109 Military Road
Buffalo, NY
Woodcraft - Buffalo, NY
(716) 674-0795
1900 Ridge Road
West Seneca, NY
Valu Home Center #18
716-297-1900
6001 Porter Road
Niagara Falls, NY
Tonawanda - Sears Hardware Stores
(716) 877-5512
1764 Sheridan Dr
Tonawanda, NY
Advantage Trim & Lumber Co
716-827-3915
601 Ohio St
Buffalo, NY
Niagara Lumber and Wood Products, Inc.
716-655-2142
47 Elm Street
East Aurora,, NY
Rockler Woodworking and Hardware #11
(716) 631-8922
5085 Transit Rd
Buffalo, NY
Fastenal- Hamburg
716-646-9661
4990 Camp Rd Hamburg, NY, 14075
Hamburg, NY
County Supply Corp
(716) 873-4700
589 Tonawanda St
Buffalo, NY
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: September 12, 2007

By Michael Springer

A T-Drill is a unique, incredible plumber's tool that I've relied on to give me a competitive edge for nearly a decade, yet most people–including many plumbers–have never heard of it. So when I was asked to review the new T-35, I was eager to see what kind of improvements they made to this amazing tool.

A T-Drill pulls a tee out of a continuous run of copper tubing. It consists of a drill motor with a high-tech business end that does the holding, drilling, and forming. Here's how it works: support legs at the head of the drill hold it centered on a piece of tubing. With the desired outlet-size T-Drill head attached, a pilot hole is drilled into the tube; then, with the bit still in the tube, two forming pins built into the pilot bit are extended by rotating a collar on the head.

After engaging the reverse-feed mechanism lever, the support legs push against the tubing, and the spinning forming pins back out of the tube, leaving a tee outlet of the proper size. And all of this is done in mere seconds.

Then the branch, or outlet, section of tubing is prepared by placing it in a T-Drill notcher, where it is cut to the sameradius as the tube run so the branch does not project into the run of tube. The notcher also leaves two dimples on the branch. These serve as a depth stop, an alignment guide, and provide for easy inspection of the joint.

Click here to read full article from Tools of the Trade

Related Articles
- Hand Tools Depew NY
The Sonic Tape, a distance-measuring device from AGL Lasersource can be used to determine length, width, and height and to compute area and volume. The tool has a range from 2 feet to 50 feet and an accuracy of 99.5 percent.
- Hitachi KM 12VC Router Combination Kit Depew NY
- Drywall Cutting and Multifunction Bench Depew NY
- Home Repair Tools Depew NY
- Festool Joining System Depew NY
- Festool C12 Cordless Drill Depew NY
- INNOVA® 3100 Tools Depew NY
- Framing Square Depew NY
- Hidden-Fastener Tool Depew NY
- Graphisoft EcoDesigner Depew NY