Drywall Cutting and Multifunction Bench West Islip NY

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights.

Local Companies

Roberts Plywood Co.
800-422-4944
45 North Industry Court
Deer Park, NY
Costello's Ace Hardware
(631) 467-6565
2120 Middle Country Rd, Pathmark
Centereach, NY
Comercial Tortuguero, Inc
(787) 858-2965
Carr #2 Km 41.3
Vega Baja, NY
Ferreteria Solar El Almacigo, Inc
(787) 856-2670
Bo Almacigo Bajo Carr 371 Km 1.4
Yauco, NY
Lake Ronkonkoma-Sears Hardware Stores
(631) 738-9457
585 Portion Rd
Lk Ronkonkoma, NY
EXOTIC WOODS USA
(631) 651-8651
698 Fort Salonga Rd
Northport, NY
Suburban Mills
631-351-6445
16 Railroad St
Huntington Station, NY
Kass Ind Supply/Islandia
(631) 234-0740
3104 Expressway Drive South Islandia, NY, 11749
Islandia, NY
Ferreteria Amador
(787) 898-4060
Buzon 94 Carretera 2 Km 88.3
Hatillo, NY
The Home Depot
(516)997-9595
86 Jericho Turnpike
Jericho, NY
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 14, 2008

By Section Editor: Mike Morris

Drywall Cutting

The BladeRunner drywall cutting tool is an amazing innovation that does the seemingly impossible. The tool separates into two, and then, connected only by powerful built-in magnets, the half placed on one side of a drywall sheet precisely follows the cut line of the tool half on the opposite side, scoring both sides of 1/2-inch or 5/8-inch drywall simultaneously to make straight, curved, or angle cuts in a single pass. Price: $80. 866-562-4229. GoldblattBladeRunner.com .

Multifunction Bench

Vika USA

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights. The MDF-surface work table setup includes a surge-protected 120-volt power strip. Price: $150. 800-845-2872. vikausa.com .

Click here to read full article from Tools of the Trade