Drywall Cutting and Multifunction Bench Scarsdale NY

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights.

Local Companies

Soundview Hardware
(516) 944-1757
3A Soundview Market Place, Clearview Cinema Theater
Port Washington, NY
Fastenal- Suffern
845-357-9515
11 Washington Avenue Suffern, NY, 10901
Suffern, NY
Airport Hardware
(201) 935-7780
111 Moonachie Ave
Moonachie, NJ
Shields Hardware
516-767-0300
267-271 Main St
Port Washington, NY
The Home Depot
(201)868-8125
7605 Tonnelle Avenue
North Bergen, NJ
Costello's Ace Hardware
(516) 280-7885
2323 Jericho Turnpike, In Pathmark Shopping Center/Near Charlie Brown's
Garden City Park, NY
Allied Building
(201) 935-0800
15 East Union Avenue East Rutherford, NJ, 07073
East Rutherford, NJ
On Time Supply
845-352-8600
14 Melnick Dr Monsey, NY, 10952
Monsey, NY
Morales Home Center Express
718-665-8380
2800 Third Ave
Bronx, NY
The Home Depot
(201)226-9929
99 State Route 17 North
Lodi, NJ

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 14, 2008

By Section Editor: Mike Morris

Drywall Cutting

The BladeRunner drywall cutting tool is an amazing innovation that does the seemingly impossible. The tool separates into two, and then, connected only by powerful built-in magnets, the half placed on one side of a drywall sheet precisely follows the cut line of the tool half on the opposite side, scoring both sides of 1/2-inch or 5/8-inch drywall simultaneously to make straight, curved, or angle cuts in a single pass. Price: $80. 866-562-4229. GoldblattBladeRunner.com .

Multifunction Bench

Vika USA

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights. The MDF-surface work table setup includes a surge-protected 120-volt power strip. Price: $150. 800-845-2872. vikausa.com .

Click here to read full article from Tools of the Trade