Drywall Cutting and Multifunction Bench Saratoga Springs NY

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights.

Local Companies

Fastenal- Mechanicville
518-899-5835
2381 Route 9 Bldg 2 Suite 4 Mechanicville, NY, 12118
Mechanicville, NY
LOWE'S OF SARATOGA SPRINGS, NY
518 583-3777
10 LOWE'S DRIVE SARATOGA SPRINGS, NY, 12866
Saratoga Springs, NY
Mechanicville Co Living Center
518-664-7661
133 N Central Avenue
Mechanicville, NY
Clifton Park - D
(518) 383-6910
15 Park Ave
Clifton Park, NY
Kmart 9274 / Cross Merch
(518) 692-9608
1251 State Rte 29
Greenwich, NY
Noble Ace Hardware
(518) 761-6777
80 William St, Hannaford on Rte. 9
South Glens Falls, NY
Lowe's of Glenville
518-952-8789
93 Freemans Bridge Rd Glenville, NY, 12302
Glenville, NY
Burnt Hills Hardware & Supply Co
(518) 399-8141
217 Kingsley Rd
Burnt Hills, NY
Lowe's
(518) 348-2940
476 Route 146
Halfmoon, NY
Wilton Mall
(518) 583-8500
3065 Route 50
Saratoga Spgs, NY

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 14, 2008

By Section Editor: Mike Morris

Drywall Cutting

The BladeRunner drywall cutting tool is an amazing innovation that does the seemingly impossible. The tool separates into two, and then, connected only by powerful built-in magnets, the half placed on one side of a drywall sheet precisely follows the cut line of the tool half on the opposite side, scoring both sides of 1/2-inch or 5/8-inch drywall simultaneously to make straight, curved, or angle cuts in a single pass. Price: $80. 866-562-4229. GoldblattBladeRunner.com .

Multifunction Bench

Vika USA

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights. The MDF-surface work table setup includes a surge-protected 120-volt power strip. Price: $150. 800-845-2872. vikausa.com .

Click here to read full article from Tools of the Trade