Drywall Cutting and Multifunction Bench Oakland Gardens NY

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights.

Local Companies

New York Lumber Co Inc
(718) 774-8900
600 Utica Ave
Brooklyn, NY
Fastenal- Brooklyn
718-609-9435
190 West St. Section 1B Brooklyn, NY, 11222
Brooklyn, NY
A G Locksmith & Hardware
(718) 497-5882
347 Knickerbocker Ave
Brooklyn, NY
The Home Depot
(201)521-9437
440 Route 440
Jersey City, NJ
Queens -Sears Hardware Stores
(718) 776-8156
22005 Hillside Ave
Queens Vlg, NY
Monster Woodshop
888-506-6678
607 18th Street
Brooklyn, NY
Palmer Ace Hardware
(201) 262-0900
940 Kinderkamack Rd, Charlie Browns Restaurant in Oradell
River Edge, NJ
Fastenal- Woodside
718-507-8193
57-08 37th Avenue Woodside, NY, 11377
Woodside, NY
Ace Hardware of Rockville Centre
(516) 568-2301
315 Sunrise Hwy, between Morris and N.Park
Rockville Centre, NY
The Home Depot
(201)226-9929
99 State Route 17 North
Lodi, NJ
Data Provided by:
  

Provided By:

Source: TOOLS OF THE TRADE Magazine
Publication date: November 14, 2008

By Section Editor: Mike Morris

Drywall Cutting

The BladeRunner drywall cutting tool is an amazing innovation that does the seemingly impossible. The tool separates into two, and then, connected only by powerful built-in magnets, the half placed on one side of a drywall sheet precisely follows the cut line of the tool half on the opposite side, scoring both sides of 1/2-inch or 5/8-inch drywall simultaneously to make straight, curved, or angle cuts in a single pass. Price: $80. 866-562-4229. GoldblattBladeRunner.com .

Multifunction Bench

Vika USA

The Twofold Workbench & Scaffold from Vika USA is lightweight yet rated to support up to 500 pounds. The 19x46-inch work platform folds flat for transport and opens to 22- and 32-inch heights. The MDF-surface work table setup includes a surge-protected 120-volt power strip. Price: $150. 800-845-2872. vikausa.com .

Click here to read full article from Tools of the Trade