Drainage System Testing Utica NY

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system in Utica. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested.

Local Companies

Distinguish Design
(315) 247-4451
5081 SPRING ROAD
VERONA, NY
National Property Inspections
(315) 735-0793

Utica, NY
Home Detective Home Inspection Svc
(518) 372-6597
1579 Valencia Rd
Niskayuna, NY
Home Tek
(845) 794-8122
21 Treasure Lake Rd
Rock Hill, NY
Amerispec Home Inspection
(845) 627-2536
193 Main St
Nanuet, NY
Lamb's Construction Inc
(315) 363-5537
146 E. Campbell Ave
Sherrill, NY
Pilipczuk Consulting Engineers
(315) 724-4796

Utica, NY
Independent Consolidated Inspection Services Inc
(315) 735-5233
1410 Albany St
Utica, NY
All Around Contrctng Corp
(516) 354-5474
100 Nottingham Rd
New Hyde Park, NY
Rc Professional Home Inspections Llc
(718) 815-1570

Staten Island, NY

Provided By:

Author: Andrew Karundu

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested. Its appropriate that this is done at least twelve hours after jointing the last pipe. There are various methods of checking the system. This ensures that the system is air tight to avoid foul smells and leakages along the lines.

The testing of drainage pipes after laying commences with the following method. First the lower end of the pipe and all junctions are securely stopped. The whole length is then filled with water. After filling with water, a stopper is inserted at the top leaving a pipe attached with drain plug. This pipe is bent at ninety degrees and terminated at an elevated tank. The vertical distance of elevation should be at least one meter. This will give gravity flow.

In testing the drainage pipes, water is poured into the header tank. This is kept full for atleast three hours. It allows absorption to take place. After this time, the tank is topped up and testing commences. After a period of thirty minutes have elapsed check the water level in the tank. The water level in the header tank should not have fallen. If has dropped by there millimeters then the test is satisfactory. Give one hour and check the levels.

After testing the drain pipes and they fail the test, check the point of leakage. Its important to note that tests are run on pipes laid in trenches but are not covered. The point of leakage is then noted and fixed. This is done using a strong concrete surround with fine aggregates. A minimum cover of one hundred and fifty millimeters is done. Tests are then done again and confirmed. After passing the test, back filling is then done for the trenches.

About the Author:

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

Article Source: http://www.articlesbase.com/remodeling-articles/how-to-test-drainage-pipes-after-laying-1069913.html

Related Articles
- Central Heating System Utica NY
Central heating is very different from local heating in the way heat is generated. In central heating, heat generation occurs in one place, such as a furnace room in a house or a mechanical room in a large building through the combustion of fossil fuel in a furnace or boiler.
- Regular Roof Maintenance and Inspections Utica NY
- Growing Tomatoes Utica NY
- Gutters Utica NY
- Fixtures and Products for the Bath Utica NY
- How to Design and Install a Radiant Floor Heating System Utica NY
- How to Diagnose and Clear Cloudy Swimming Pool Water Utica NY
- Creating Herb Gardens Utica NY
- Preventing Basement Floods Utica NY