Drainage System Testing Oneonta NY

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system in Oneonta. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested.

Local Companies

Bug Off Pest Control
(518) 843-8234
1028 Stone Arabia Rd
Fort Plain, NY
A & M Home Inspectors
(718) 980-0267
310 Ross Ave
Staten Island, NY
Absolute Home Inspection Services
(845) 463-9971
7 Danspence Rd
Poughkeepsie, NY
Professional Bldg Inspections
(518) 792-9001
PO Box 226
Lake George, NY
Pillar To Post Professional Home Inspection
(631) 898-0186
Main
Westhampton Beach, NY
Bock Engineering Contractors
(914) 723-7890
189 Brook St
Scarsdale, NY
Ferrante & Memmelaar Homes
(845) 294-8242
2713 Route 17M
New Hampton, NY
Stuart Schrager P.E. Llc
(845) 634-0584
6 Lady Godiva Way
New City, NY
Home Inspections Inc
(518) 792-4237

Galway, NY
Ridgeview Services Inc
(845) 895-8030
12 Empire Dr
Wallkill, NY

Provided By:

Author: Andrew Karundu

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested. Its appropriate that this is done at least twelve hours after jointing the last pipe. There are various methods of checking the system. This ensures that the system is air tight to avoid foul smells and leakages along the lines.

The testing of drainage pipes after laying commences with the following method. First the lower end of the pipe and all junctions are securely stopped. The whole length is then filled with water. After filling with water, a stopper is inserted at the top leaving a pipe attached with drain plug. This pipe is bent at ninety degrees and terminated at an elevated tank. The vertical distance of elevation should be at least one meter. This will give gravity flow.

In testing the drainage pipes, water is poured into the header tank. This is kept full for atleast three hours. It allows absorption to take place. After this time, the tank is topped up and testing commences. After a period of thirty minutes have elapsed check the water level in the tank. The water level in the header tank should not have fallen. If has dropped by there millimeters then the test is satisfactory. Give one hour and check the levels.

After testing the drain pipes and they fail the test, check the point of leakage. Its important to note that tests are run on pipes laid in trenches but are not covered. The point of leakage is then noted and fixed. This is done using a strong concrete surround with fine aggregates. A minimum cover of one hundred and fifty millimeters is done. Tests are then done again and confirmed. After passing the test, back filling is then done for the trenches.

About the Author:

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

Article Source: http://www.articlesbase.com/remodeling-articles/how-to-test-drainage-pipes-after-laying-1069913.html

Related Articles
- Creating Herb Gardens Oneonta NY
Herbs have been around since time immemorial and served different kinds of purposes. They have been used to treat illness and flavour cooking; they were even believed to have magical powers. Do you want to have your own herb garden? Here are a few ideas on how to establish an herb garden.
- Regular Roof Maintenance and Inspections Oneonta NY
- Fixtures and Products for the Bath Oneonta NY
- Growing Tomatoes Oneonta NY
- How to Diagnose and Clear Cloudy Swimming Pool Water Oneonta NY
- How to Design and Install a Radiant Floor Heating System Oneonta NY
- Central Heating System Oneonta NY
- Preventing Basement Floods Oneonta NY
- Gutters Oneonta NY