Drainage System Testing New Windsor NY

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system in New Windsor. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested.

Local Companies

Abar Sewer Service, Inc.
845-294-5314
25 Green Street
Goshen, NY
Ward Pavements, Inc.
845-294-8341
P.O. Box 427
Goshen, NY
Winter Sun Construction Inc.
(845) 256-1031
43 North Chestnut Street
New Paltz, NY
Larenco, LLC
(914) 629-0798
PO Box 1502
Highland, NY
Living Art Landscapes Inc.
(845) 691-8992
428 N. Riverside Rd
Highland, NY
Carriage Park
845-294-3400
102 Cantor Court
Goshen, NY
Esposito & Associates
845-294-0558
262 Greenwich Avenue
Goshen, NY
Trottown Trucking, Inc.
845-591-5026
1 McNamara Lane
Goshen, NY
Water Solutions of New Paltz, Inc.
(845) 255-3408
PO Box 221
New Paltz, NY
David Clouser & Associates
(845) 256-9600
1 Paradies Lane, Suite 200
New Paltz, NY

Provided By:

Author: Andrew Karundu

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested. Its appropriate that this is done at least twelve hours after jointing the last pipe. There are various methods of checking the system. This ensures that the system is air tight to avoid foul smells and leakages along the lines.

The testing of drainage pipes after laying commences with the following method. First the lower end of the pipe and all junctions are securely stopped. The whole length is then filled with water. After filling with water, a stopper is inserted at the top leaving a pipe attached with drain plug. This pipe is bent at ninety degrees and terminated at an elevated tank. The vertical distance of elevation should be at least one meter. This will give gravity flow.

In testing the drainage pipes, water is poured into the header tank. This is kept full for atleast three hours. It allows absorption to take place. After this time, the tank is topped up and testing commences. After a period of thirty minutes have elapsed check the water level in the tank. The water level in the header tank should not have fallen. If has dropped by there millimeters then the test is satisfactory. Give one hour and check the levels.

After testing the drain pipes and they fail the test, check the point of leakage. Its important to note that tests are run on pipes laid in trenches but are not covered. The point of leakage is then noted and fixed. This is done using a strong concrete surround with fine aggregates. A minimum cover of one hundred and fifty millimeters is done. Tests are then done again and confirmed. After passing the test, back filling is then done for the trenches.

About the Author:

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

Article Source: http://www.articlesbase.com/remodeling-articles/how-to-test-drainage-pipes-after-laying-1069913.html

Related Articles
- Creating Herb Gardens New Windsor NY
Herbs have been around since time immemorial and served different kinds of purposes. They have been used to treat illness and flavour cooking; they were even believed to have magical powers. Do you want to have your own herb garden? Here are a few ideas on how to establish an herb garden.
- Central Heating System New Windsor NY
- Fixtures and Products for the Bath New Windsor NY
- Gutters New Windsor NY
- How to Diagnose and Clear Cloudy Swimming Pool Water New Windsor NY
- Growing Tomatoes New Windsor NY
- How to Design and Install a Radiant Floor Heating System New Windsor NY
- Preventing Basement Floods New Windsor NY
- Regular Roof Maintenance and Inspections New Windsor NY