Drainage System Testing Corning NY

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system in Corning. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested.

Local Companies

Brucie R J Property Inspector
(607) 962-0991
191 Princeton Ave
Corning, NY
Home Inspections Inc
(518) 882-6808

Galway, NY
Crown Mark Electrical Cntrctg
(718) 227-0375
4442 Arthur Kill Rd
Staten Island, NY
Above Grade Home Inspections
(845) 565-1122
25 Glenwood Dr
Wallkill, NY
Northern Home Inspections & Pest Control
(914) 245-9683
3327 Peter Ln
Yorktown Heights, NY
Cystal Valley Excavation/Mulch/Gravel
607-765-8124
20 River Road
Corning, NY
Charkey Edward S
(845) 638-3230
47 Capral Ln
New City, NY
Riverview Home Inspection Svcs
(518) 622-2966
383 Blackhead Mountain R
Round Top, NY
Esi
(845) 744-4848
2646 New Prospect Rd
Pine Bush, NY
Home Consultants Inc
(631) 285-7800
230 Terryville Rd
Port Jefferson Station, NY

Provided By:

Author: Andrew Karundu

Drainage pipes start from the first manhole or inspection chamber to the septic tank or sewer system. After laying the pipes, before use the drains should be tested. Each section in between the manholes should be tested. Its appropriate that this is done at least twelve hours after jointing the last pipe. There are various methods of checking the system. This ensures that the system is air tight to avoid foul smells and leakages along the lines.

The testing of drainage pipes after laying commences with the following method. First the lower end of the pipe and all junctions are securely stopped. The whole length is then filled with water. After filling with water, a stopper is inserted at the top leaving a pipe attached with drain plug. This pipe is bent at ninety degrees and terminated at an elevated tank. The vertical distance of elevation should be at least one meter. This will give gravity flow.

In testing the drainage pipes, water is poured into the header tank. This is kept full for atleast three hours. It allows absorption to take place. After this time, the tank is topped up and testing commences. After a period of thirty minutes have elapsed check the water level in the tank. The water level in the header tank should not have fallen. If has dropped by there millimeters then the test is satisfactory. Give one hour and check the levels.

After testing the drain pipes and they fail the test, check the point of leakage. Its important to note that tests are run on pipes laid in trenches but are not covered. The point of leakage is then noted and fixed. This is done using a strong concrete surround with fine aggregates. A minimum cover of one hundred and fifty millimeters is done. Tests are then done again and confirmed. After passing the test, back filling is then done for the trenches.

About the Author:

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

Article Source: http://www.articlesbase.com/remodeling-articles/how-to-test-drainage-pipes-after-laying-1069913.html

Related Articles
- Creating Herb Gardens Corning NY
Herbs have been around since time immemorial and served different kinds of purposes. They have been used to treat illness and flavour cooking; they were even believed to have magical powers. Do you want to have your own herb garden? Here are a few ideas on how to establish an herb garden.
- Fixtures and Products for the Bath Corning NY
- Central Heating System Corning NY
- How to Diagnose and Clear Cloudy Swimming Pool Water Corning NY
- Regular Roof Maintenance and Inspections Corning NY
- Growing Tomatoes Corning NY
- How to Design and Install a Radiant Floor Heating System Corning NY
- Preventing Basement Floods Corning NY
- Gutters Corning NY