Building Masonry Feature Walls Fredonia NY

Feature walls in Fredonia are made of materials like masonry, brickwork, resin coatings, timber, concrete and gypsum. This can be built up during construction of the house mostly concrete, timber, brickwork and masonry or cladded. For other types they are normally cladding's on finished walls. This are found in niches, above chimney breasts, lobby, lounge, bay window, dinning and family room walls.

Local Companies

General Lumber Hardware
(315) 336-2600
529 Erie Blvd W
Rome, NY
Pleasantville Bldg Material Supl
(914) 747-1100
150 Sunnyside Ave
Pleasantville, NY
Northeast Panel and Truss
(845) 339-3656
9 Kieffer Ln
Kingston, NY
Bellerose Lumber
(718) 347-3321
24815 Jericho Tpke
Bellerose, NY
Rucker Lumber Inc
(716) 941-5223
Boston State Rd
Boston, NY
Mr 2Nd's Bargain Outlet
(315) 446-1228
3480 Erie Blvd E
Syracuse, NY
Building Supply American
(347) 297-5039
150 Bruckner Blvd
Bronx, NY
George Lumber & Bldg Materials Inc
(315) 429-9962
40 McKinley Ave
Dolgeville, NY
Lowe's of Vestal
(607) 770-4442
225 Sycamore St
Vestal, NY
Rogers & Tenbrook of Dansville
(585) 335-2256
43 West Ave
Dansville, NY

Provided By:

How to make a masonry feature wall

Author: Andrew Karundu

Feature walls are made of materials like masonry, brickwork, resin coatings, timber, concrete and gypsum. This can be built up during construction of the house mostly concrete, timber, brickwork and masonry or cladded. For other types they are normally claddings on finished walls. This are found in niches, above chimney breasts, lobby, lounge, bay window, dinning and family room walls. The level of works determines the type of finish to be used.

When making feature walls, the location is very important. For niches coats have good aesthetic as they are rich in color. When working in the rooms check the corresponding finish to give a contrast to the wall. Commence the work by hacking off the surfaces for finished walls to receive the finish. Use chisel dressed fair face stones with a thickness of one inch. Cut the stones into slates of atleast one foot in length and various widths.

In masonry feature wall construction, stone slates are patterned as desired. Use a straight edge at the bottom to level the works. Spread cement grouting to the pieces and commence working from the bottom upwards. Lay the pieces block wise to the end of hacked area. Remember to pound them to spread the cement behind to avoid hollow spaces. Use joint less bonding. Keep joints alternate on each row to the top and complete marked area. Brush off cement.

After the feature masonry wall is complete, rake out the bonding horizontal joints. Use a rounded bar of a quarter inch for horizontal key pointing. Remove arising debris and make good floor joint if the wall had commenced from the floor. When this is done give a week and to allow curing. Paint clear vanish in Matt or gloss as desired. For a rustic finish don't varnish. The method can be repeated for brickwork, rustic tiles, rubble and grano materials.

About the Author:

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

Article Source: http://www.articlesbase.com/remodeling-articles/how-to-make-a-masonry-feature-wall-991942.html